TODD 1/4″ Wall Polyethylene Water/Holding Tanks

Polyethylene tanks will not emit waste odors or change the taste of fresh potable water.

Manufactured from SURPASS® polyethylene, these tanks meet or exceed US Coast Guard (Type III CFR 177.1520) requirements. Standard tanks include two 1 1/2″fill/drain ports and two 1/2″ vent/supply ports-which enables use as a sanitation holding tank or for potable water storage.

Each Todd Tank comes with the necessary pre-drilled and threaded openings so that it can be configured as either a Water Tank or as a Holding tank. Simply remove the appropriate plugs and screw in the necessary hose fittings (Fitting Relocation Kits sold separately, see below).  One-year warranty.

Features

• All openings are female NPT (National Pipe Threads)
• All openings are located in the same relative position on one end of the tank.
• Includes two 1 1/2″ NPT and two 1/2″ NPT opening
• Each tank fully complies with FDA regulation CFR 177.1520.
• All tanks satisfy all United States Coast Guard standards.
• Polyethylene tanks will not emit waste odors or change the taste of fresh potable water.

What’s Included

• Tank
• One 1/2″ NPT Plug to Block off unused Vent Port
• One 1-1/2″ NPT Plugs to Block off unused Hose Port
• Small Roll of Teflon Tape

Fitting Requirements for Installation

• Water Supply Tanks: One 1 1/2″ and two 1/2″ hose fittings (Todd Water Tank Straight Pipe-to-Hose Adapter Kit,  93-2222 or Water Tank 90-Degree Pipe-to-Hose Adaptor Kit,  93-2223)
• Waste Water Holding Tank: Two 1-1/2″ and one 1/2″ hose fittings (Todd Holding Tank Straight Pipe-to-Hose Adapter Kit 93-2220, Model 597468 or Holding Tank 90 Degree Pipe-to-Hose Adapter Kit 93-2221, Model 597484)